Top Ring for 10 ft trampoline Netting (Type A)

• Complete Set Includes Fiber glass rods
  
• To fit 10' frames using CURVED poles
  
  This is a continuous rod that fits through top of netting around full top cicumference of trampoline
  They are not seperate rods as may appear in photo they are all joined together and only suit trampolines that use this system

NOTE This Top Ring can be used on a GSD trampoline mode (was sold by Smyths, discontinued at time of writing) - Although the GSD used individual poles the pole cap (T section) connectors will allow this rod fit through, therefore if you have a broken top ring piece or pieces on a GSD trampoline, you can purchase this as replacement.  To install:  remove all the existing top ring bars and take the T sections down off the top of the poles, thread this top ring through the net until you get to an opening,  then fit a pole cap, then push it through  until you fit another cap, continue until all caps are fitted, then fit the top ring joiner provided with this product and lift it up onto the  poles

* Please Note that the diameter of these flexi rods will be less than the diameter of the trampoline frame they are listed for. This is because they are sized for trampolines with poles that curve in at the top.

(If you have a trampoline where the top ring is the same diameter as the trampoline, please contact us to see if we have a suitable solution)

* Please note these flexi rods DO NOT fit the Tech Sport 10ft trampoline with existing tech sport T connectors, it could be adapted by changing these T connectors for our 25mm G Caps
(for our Tech Sport parts please see here)